29
PARENT UNIT OPERATION
5.4 Monitoring mode
Every time you turn on the parent unit, you enter the
SINGLE-CAM mode. The screen displays image of a particular baby
unit in full screen. If there is more than one baby unit in your system,
you can switch between baby units in SINGLE-CAM mode. You
can also monitor in SPLIT-VIEW mode, where the screen displays a
maximum of four baby units in one screen, or PATROL mode, where
the screen switches between all paired baby units in sequence every 7
seconds.
In SINGLE-CAM mode:
Press to view image of the next baby unit.
Press repeatedly to enter SPLIT-VIEW or PATROL mode.
In SPLIT-VIEW mode:
Press , , or to select a baby unit.
Press to view images from the selected baby unit temporarily in
SINGLE-CAM mode. It returns to
SPLIT-VIEW mode after 10 seconds.
Press repeatedly to switch to SINGLE-CAM or PATROL mode.
In PATROL mode:
In PATROL mode: The parent unit automatically
switches every 7 seconds in sequence between the paired baby
units.
Press repeatedly to change to SINGLE-CAM or SPLIT-VIEW
mode.
Note
The parent unit is muted while in SPLIT-VIEW or PATROL mode.
5.5 To Turn the Screen On or Off
Press and hold on the parent unit at any time.
•
•
•
•
•
•
•
•
To Next Page
Loading...
