77
Appendix
California Energy Commission battery charging
testing instructions
This deskset is set up to comply with the energy-conserving standards right
out of box. These instructions are intended for California Energy Commission
(CEC) compliance testing only. When the CEC battery charging testing mode
is activated, all telephone functions, except backup battery charging, will be
disabled.
To activate the CEC battery charging testing mode:
1. On the CM18445/AM18447 console, press MENU/SELECT.
2. Press or to scroll to Registration, then press MENU/SELECT
or /SKIP.
3. Press or to scroll to Deregistration, then press MENU/SELECT
or /SKIP.
4. Press or to choose this deskset, then press MENU/SELECT or /SKIP.
5. Press or to scroll to Yes, then press MENU/SELECT or /SKIP. The
console shows Deregistering Deskset X (X represents the extension
number).
The process takes up to 10 seconds to complete. When the deskset
successfully enters the CEC battery charging testing mode, its screen displays
1) Press MENU on Console ->Registration ->Register Ext. and 2) Press #
on this extension to register. alternately. You hear a confirmation tone.
If the deskset fails to enter this mode, repeat all the steps above.
To activate the CEC battery charging testing mode:
Register your deskset back to the CM18445/AM18447 console. See Add and
register a deskset on page 8 for the instructions.
To Next Page
Loading...
Need help?
General
