22
Basic Operation
Audible Indicators
This system gives you voice prompts for feature operations and voice
confirmations when you press a button or complete an operation.
Setting Day/Time
1. Make sure the answering system is on.
2. Press TIME/SET. The system announces the clock setting, then announces:
“To Set Day and Time, press TIME/SET.”
3. Press TIME/SET.
4. Press SELECT until the system announces the correct day, then press
TIME/SET.
5. Press SELECT until the system announces the correct hour, then
press TIME/SET.
6. Press SELECT until the system announces the correct minute, then
press TIME/SET. The system announces the current clock setting.
Note: To advance the minutes by 10, press and hold SELECT.
About Mailboxes
This answering system has three voice mailboxes. Callers using a touch tone
phone can select the mailbox in which their messages will be recorded
by pressing 1, 2 or 3. Otherwise, messages will be recorded in Mailbox 1.
About Announcements
• You can record two different announcements — one for normal answering
and one for when you’ve set the system to play the announcement only.
• Use normal answering when you want the system to record callers’
messages. Use Announce Only when you want to give information to
callers without accepting messages.
• If you choose not to record an announcement, the system answers with a
pre-recorded announcement.
• The normal answering pre-recorded announcement says: “Hello. I’m unable
to answer your call right now. Please leave your name, number and a
message after the tone.” The Announce Only pre-recorded
announcement says: “Hello, I’m unable to answer your call right now.
Please call again. Thank you.”
• By setting Announce Only to ON or OFF, you decide which announcement your
callers will hear when the system answers a call (the system comes set for
normal answering , with Announce Only turned off). See “Set Announce
Only” , located in the Feature Summary chart later in this section, to change
your announcement selection.
Answering System Operation At The Base
To Next Page
Loading...
