VTech CS6029CA User Manual

42
43
Install | Set up Operate Configure | Settings
Area code settings
Set home area code
If you dial your local calls using only
seven digits (area code not required),
you can program your home area code
so that when you receive a call within
your local area, the telephone number
is automatically stored without the area
code in the caller ID log.
1. Press when the phone is not in
use.
2. Press ▼/▲ to choose Settings, and
then press to select.
3. Press ▼/▲ to choose Home area
code, and then press to select.
4. Use the dialing keys to enter a three-
digit home area code.
• Press on the handset or
DELETE X on the telephone base
to delete a digit.
• Press and hold on the
handset to delete all digits.
5. Press to save.
• The screen returns to the previous
menu.
• You hear a confirmation tone.
NOTE
• If, in the future, your telephone
service provider requires you to dial
the area code when making a local
call, -OR-, if you move to a location
that requires it, delete the home area
code you have already programmed,
following the steps above. After you
have deleted the home area code, _
_ _ will appear on the display.
Ringer
Set number of rings
You can set the answering system to
answer an incoming call after two, three,
four, five or six rings; or toll saver.
If you choose toll saver, the answering
system answers a call after two rings
when you have new messages, or
after four rings when you have no new
messages. This enables you to check
for new messages and avoid paying
unnecessary long distance charges if
you are calling from outside your local
area.
1. Press when the phone is not in
use.
2. Press ▼/▲ to scroll Answering sys,
and then press to select.
3. Press ▼/▲ to scroll Ans sys setup,
and then press to select.
4. Press ▼/▲ to scroll # of rings, and
then press to select.
5. Press ▼/▲ to choose 2, 3, 4, 5, 6, or
Toll saver, and then press to
select.
• You hear a confirmation tone.
Set ringer tone
You can choose from different ringer
tones for each handset and the
telephone base.
1. Press when the phone is not in
use.
2. Press ▼/▲ to choose Ringers, and
then press to select.
3. Press ▼/▲ to choose Ringer tone,
and then press to select.
4. Press ▼/▲ to sample each ringer
tone.
5. Press to save.
• The screen returns to the previous
menu.
• You hear a confirmation tone.
NOTE
• If you turn off the ringer volume, you
will not hear ringer tone samples.

VTech CS6029CA Specifications

General

Brand	VTech
Model	CS6029CA
Category	Cordless Telephone
Language	English