VTech CS6029CA User Manual

16
17
Install | Set up Operate Configure | Settings
Connect the charger
NOTES
• Use only the adapters provided.
• Make sure the electrical outlets are
not controlled by wall switches.
• The adapters are intended to be
correctly oriented in a vertical or floor
mount position. The prongs are not
designed to hold the plug in place
if it is plugged into a ceiling, under-
the-table or cabinet outlet.
Charge the battery
Place the handset in the telephone base
or charger to charge.
Once you have installed the battery,
the handset LCD display indicates the
battery status (see the table below).
Battery
indicators
Battery
status
Action
The screen is
blank or shows
Put in charger
and flashes.
Battery has no
charge or very
little
charge. The
handset cannot
be used.
Charge without
interruption
(at least 30
minutes).
The screen
shows
Low battery
and flashes.
Battery has
enough charge
to be used for a
short time.
Charge without
interruption
(at least 30
minutes).
The screen
shows
HANDSET X.
Battery is
charged.
To keep
the battery
charged,
place it in the
telephone base
or charger
when not in
use.
When it is fully charged, you can expect
the following performance:
Operation Operating time
While in handset use
(talking*)
7 hours
While in speakerphone
mode (talking*)
3.5 hours
While not in use
(standby**)
5 days
* Operating times vary depending
on your actual use and the age of the
battery.
** Handset is not charging or in use.
NOTES
• Place the handset in the charger will
bypass the set date and time, and
voice guide.
• For best performance, keep the
handset in the charger when not in
use.
• The battery is fully charged after 12
hours of continuous charging.
• If you place the handset in the charger
without plugging in the battery, the
screen displays NO BATTERY.
Check the battery level
After you have installed the battery,
check the battery level on the handset
screen.
• If the battery icon is [X], [X] or [X],
then go to Set the date and time and
Set the answering system through
voice guide.
• If the screen is blank, or flashes,
then the battery needs to be
charged. Go to Charge the battery
before you do any setting or
operation.
Check for dial tone
Press . If you can hear a dial tone, the
installation is successful.
If you do not hear a dial tone
• Make sure the installation
procedures described above are
properly done.
• It may be a wiring problem. If you
have changed your telephone
service to digital service from a cable
company or a VoIP service provider,
the telephone line may need to
be rewired to allow all existing
telephone jacks to work. Contact
your cable/VoIP service provider for
more information.

VTech CS6029CA Specifications

General

Brand	VTech
Model	CS6029CA
Category	Cordless Telephone
Language	English