VTech CS6114 B User Manual

3
Your telephone comes ready for tabletop use.
To mount your telephone on the wall:
Position the top hole at the back of the telephone base against the top
mounting stud [A].
Slide the telephone base down on the mounting
studs [A] and [B] until it locks into place.
1.
2.
Telephone base
[A]
[B]
Mounting
studs
Wall mounting (optional)
Once you have installed the battery, the screen indicates the battery status
(see the table below). For best performance, keep the handset in the
telephone base or charger when not in use. The battery is fully charged after
16 hours of continuous charging. Refer to the online Complete user’s manual
for battery operating times.
Battery indicators Battery status Action
The screen is blank, or
displays Place in charger
and
flashes.
The battery has very
little or no charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen displays
Low battery and
flashes.
The battery has enough
charge to be used for a
short time.
Charge without interruption
(about 30 minutes).
The screen displays
HANDSET X.
The battery is charged. To keep the battery charged,
place it in the telephone
base or charger when not
in use.
If you place the handset in the telephone base or charger without plugging in
the battery, the screen displays No battery.
Battery charging

VTech CS6114 B Specifications

Frequency and Channels

transmit frequency (handset)	1921.536-1928.448 MHz
transmit frequency (telephone base)	1921.536-1928.448 MHz
channels	5

Power Requirements

handset power requirement	2.4V Ni-MH battery
telephone base power requirement	6V AC @ 300mA
charger power requirement	6V AC @ 300mA

Memory

handset directory memory locations	30
handset directory memory digits	up to 30 digits
handset directory memory characters	15 characters