VTech CS6114 B User Manual

6
Make a call
Press and then dial the telephone number.
Answer a call
Press or any of the dialing keys (0-9, TONE or #).
End a call
Press OFF or put the handset to the telephone base or charger.
Volume
During a call, press VOL
-
or VOL
+
to adjust the
listening volume.
Mute
The mute function allows you to hear the other party but the
other party cannot hear you.
During a call, press MUTE. The screen displays Muted
until the mute function is turned off.
Press MUTE again to resume the conversation. The
screen temporarily displays Microphone on.
Call waiting
When you subscribe to call waiting service from your telephone service
provider, you hear an alert tone if there is an incoming call while you are on
another call.
Press FLASH to put the current call on hold and take the new call.
Press FLASH at any time to switch back and forth between calls.
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of the
handset without disconnecting the call. The next call rings normally at the
preset volume.
To silence the handset ringer, press OFF or MUTE and then
Ringer muted displays.
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to tone
dialing temporarily during a call. This is useful if you need to send touch-tone
signals to access your telephone banking or long distance services.
During a call, press
TONE .
Use the dialing keys to enter the relevant number. The telephone sends
touch-tone signals.
The telephone automatically returns to pulse dialing mode after you end
the call.
Redial
Each handset stores the five most recently dialed numbers. When there are
already five entries, the oldest entry is deleted to make room for the new entry.
To review and dial a number from the redial list:
Press REDIAL when the handset is not in use.
Press
CID, or REDIAL repeatedly until the desired
entry displays.
Press
to dial.
To delete a redial entry:
When the desired redial entry displays, press DELETE.
•
•
•
•
1.
2.
•
•
•
1.
2.
3.
1.
2.
3.
Ringer muted
10:15
PM 12/25
Telephone operation
CANCEL

VTech CS6114 B Specifications

Frequency and Channels

transmit frequency (handset)	1921.536-1928.448 MHz
transmit frequency (telephone base)	1921.536-1928.448 MHz
channels	5

Power Requirements

handset power requirement	2.4V Ni-MH battery
telephone base power requirement	6V AC @ 300mA
charger power requirement	6V AC @ 300mA

Memory

handset directory memory locations	30
handset directory memory digits	up to 30 digits
handset directory memory characters	15 characters