Answering machine base
1. PAGE
Press to page all registered handsets.
2. VOLUME +
During message playback: Press to increase the speaker volume.
In idle mode: Press to increase the DDA200BT base ringer volume
3. DELETE
During message playback: Press to delete the current message.
In idle mode: Press twice to delete all previously reviewed messages.
4. SKIP FORWARD
During message playback: Press to skip to the next message.
5. VOLUME –
During message playback: Press to decrease the speaker volume.
In idle mode: Press to decrease the base ringer volume.
6. 2-digit 7-seg LED Display
When answering machine is OFF.
When answering machine is OFF and no new Answering Machine messages received.
Flashing XX alternatively with OF: Answering machine is OFF and there are XX new voice messages
received where XX is from 01 to 59.
When answering machine is ON where XX is number of messages in Answering Machine memory.
Steady: No voice messages in Answering Machine.
Flashing: There are XX new voice messages received where XX is from 01 to 59.
Steady: There are ZZ old voice messages kept in the Answering Machine memory (no new voice
messages).
Flashing XX alternatively with FF: There are XX new voice messages received where XX is from 01 to
59 and the Answering Machine memory is full.
Flashing FF: Answering Machine memory is full and there are no new messages, only old messages
are kept in TAM memory.
Flashing XX alternatively with - -: Time is not set and there are XX new voice messages received
where XX is from 01 to 59.
Flashing - -: Time is not set and there are old voice messages kept in the Answering Machine
memory only (no new voice messages).
Steady: Playing the current XX incoming message.
Steady: Playing the current outgoing message (OGM).
Flashing XX alternatively with An: XX new incoming message is now recording.
An denotes that the incoming message recording is in progress.
Flashing: Remote access is in progress.
To Next Page
Loading...
Need help?
General
