VTech DS6161 User Manual

16
To access a number in the directory
while on a call:
1. Press MENU.
2. Press q or p to choose Directory,
then press SELECT.
3. Press q or p to scroll to the desired
entry.
4. Press SELECT to dial the displayed
number.
To access a number in the caller ID log
while on a call:
1. Press MENU.
2. Press q or p to choose Caller ID log,
then press SELECT.
3. Press SELECT and then press q or p
to scroll to the desired entry.
4. Press SELECT to dial the displayed
number.
To access a number in the redial list
while on a call:
1. Press REDIAL to enter the redial list.
2. Press q, p or REDIAL on the handset
repeatedly to browse to the desired
entry.
3. Press SELECT to dial the displayed
number.
• Press OFF on the handset to exit redial list,
directory or caller ID log when you are on a
call.
Find handset
Use this feature to find all system handsets.
• Press FIND HS on the telephone base
when not in use. All idle handsets ring
and display ** Paging **.
To end paging:
• Press FIND HS again on the telephone
base.
-OR-
• Press HOME, CELL , , OFF or
any of the dialing key on the handset.
-OR-
• Place the handset in the telephone base.
• Press MUTE to turn off the ringer of a
handset temporarily. Paging tone continues
on the other handset.
• Do not press and hold FIND HS for more
than four seconds. It may lead to handset
deregistration. If the handset displays To
register, see user manual, refer to the
Frequently asked questions section to
register the handset back to the telephone
base.
Redial list
Each handset stores the last 10 telephone
numbers dialed (up to 30 digits). Entries
are shown in reverse chronological order.
When there are already 10 entries, the
oldest entry is deleted to make room for
the new entry.
Review the redial list
1. Press REDIAL on the handset when the
phone is not in use.
2. Press q, p or REDIAL repeatedly to
browse.
Dial a redial list entry
1. Search for the desired entry in the
redial list (see Review the redial list).
2. When the desired entry displays, press
HOME, or to dial using the
home line, or press CELL to dial
using the cell line.
-OR-
1. Press HOME, or to use the
home line, or press CELL to use the
cell line when the handset is not in use.
2. Press REDIAL on the handset.
3. Press q or p until the desired entry
displays, then press SELECT to dial.

VTech DS6161 Specifications

Frequency and Channels

handset frequency	1921.536-1928.448 MHz
telephone base frequency	1921.536-1928.448 MHz
bluetooth frequency	2402.000-2480.000 MHz
DECT channel	5
Bluetooth channel	79

Power Requirements

handset battery	2.4V Ni-MH battery
telephone base power supply	6V DC @ 400mA
maximum power allowed by FCC and IC	variable

Memory

directory memory locations	1000 memory locations
caller ID log memory locations	50 memory locations
call block entries	20 entries