VTech DS6161 User Manual

26
Screen messages
Blocked call
An incoming call is
blocked.
Calling HS X
The handset is calling
another handset (for
intercom calls).
Cell line busy
Another handset is
using the cell line.
Cell <X> low
batt
The paired cell
device has low
battery.
C<X>:
<Service_name>
The phone receives
an alert from your cell
phone.
Downloading...
The telephone
system is
downloading the
directory from a cell
phone.
Ended
You have just ended
a call.
HS X
is calling
Another system
handset is calling (for
intercom calls).
Intercom
The device is on an
intercom call.
Intercom ended
The intercom call has
just ended.
List empty
There are no entries.
Low battery
The battery needs to
be charged.
Microphone on
Mute is off and the
person on the other
end can hear you.
Muted
You have turned
off the handset
microphone. The
other party cannot
hear you but you can
hear the other party.
New voicemail
There are new
voicemail messages
from your telephone
service provider.
No battery
The battery is not
properly installed or
there is no battery
installed.
No line
There is no
telephone line
connected.
Out of range or
no pwr at base
The telephone base
has lost power, or the
handset is out
of range.
** Paging **
The cordless handset
is paged by the
telephone base.
Pair cell
first
You need to pair a
cell phone before
makine a cell call.
Place in
charger
The battery is very
low. Place the handset
in the telephone base
for recharging.
Quiet mode off
The quiet mode is
turned off.
Ringer muted
The ringer is off
temporarily while the
device is ringing.
To power on
HS, see manual
Screen display before
handset activation.
Unable to call
You tried to make
an intercom call, but
the handset you are
calling is busy, out
of range, or has no
power.
XX missed
calls
There are calls that
have not been
reviewed in the caller
ID log.

VTech DS6161 Specifications

Frequency and Channels

handset frequency	1921.536-1928.448 MHz
telephone base frequency	1921.536-1928.448 MHz
bluetooth frequency	2402.000-2480.000 MHz
DECT channel	5
Bluetooth channel	79

Power Requirements

handset battery	2.4V Ni-MH battery
telephone base power supply	6V DC @ 400mA
maximum power allowed by FCC and IC	variable

Memory

directory memory locations	1000 memory locations
caller ID log memory locations	50 memory locations
call block entries	20 entries