76
Appendix
Expand your telephone system
The handsets provided with your telephone system are already registered.
Additional handsets registered to the telephone system are assigned
in sequential order. For instance, if you already have HANDSET 1 and
HANDSET 2, the new registered handset is assigned HANDSET 3. This
telephone system accommodates up to 12 handsets.
Add and register a handset (optional)
You can add new handsets (DS6301, purchased separately) to your
telephone system, but each handset must be registered with the telephone
base before use. When rst purchased, each expansion handset shows
Press and hold FIND HANDSET on base for 4 sec, then press # on
handset after a battery is installed. You may need to charge the handset
before registering to the telephone base. For more details on battery
charging, see the table on page 5.
To register a handset:
Press and hold /FIND HANDSET on the telephone base for about four
seconds until the red IN USE light turns on.
Press # (pound key) on the handset. Its screen shows Registering...
Please wait and it takes up to 60 seconds to complete the registration.
The handset shows HANDSET X Registered (X represents the
handset number assigned) and you hear a beep when the registration
is completed.
1.
2.
If the registration fails, the handset shows Registration failed for a few
seconds and then
Press and hold FIND HANDSET on base for 4 sec,
then press # on handset.
Try the registration process again.
You cannot register a handset if any other system handset is in use.
•
•
To Next Page
Loading...
Need help?
General
