VTech FS2615A - Register a Handset; Reset Your Phone

36
3FTFU:PVS1IPOF
You can reset your phone to the default settings. After reset, all
your personal settings, call list entries and redial list entries will
be deleted, but your phonebook remains unchanged.
Press
and
S
T
to select %&'"6-5.
Press
and you are requested to enter the 4-digit system
PIN.
Enter the 4-digit system PIN (default: ).
Press
to confirm
Press
to re-confirm.
3FHJTUFSB)BOETFU
Your handset is pre-registered to the base station. Up to five
handsets can be registered to a a single base station.
If for some reason, the handset is not registered to the base
station, 3&(*45&3 will be displayed on the handset screen,
register your handset following the process below.
Press and hold
on the base station for about five
seconds, until the base station LED light flashes. The base
station is entered into registration mode.
Press
and
S
T
to select 3&(*453"5*0/.
Press
and you are requested to enter the 4-digit system
PIN (default: ).
Enter the 4-digit system PIN and press
to confirm.
NOTES
If the handset registration is successful, the handset will
automatically be allocated the next available handset number.
This handset number is shown in the handset display in
standby mode. If the handset registration is unsuccessful, the
will still flash.
If the handset registration is not successful, the handset
will beep twice and return to idle mode, and then show
3&(*45&3 again.
1.
2.
3.
4.
5.
1.
2.
3.
4.
•
•