VTech Get Ready for School Learning Desk - GETTING STARTED; Battery Removal and Installation; Important Battery Information

6
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
• Make sure the main unit is turned Off.
• Find the battery cover located on the back of
the unit, use a coin or screwdriver to loosen the
screw and then open the battery cover.
• Remove old batteries by pulling up on one end
of each battery.
• Install 4 new AA (AM-3/LR6) batteries following
the diagram inside the battery box. (For best
performance, alkaline batteries or fully charged
Ni-MH rechargeable batteries are recommended.)
• Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
IMPORTANT: BATTERY INFORMATION•
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be
used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.