13
Getting Started
Registration of Accessory Handset
After charging, the screen will display:
• Enter the BASE ID Code located on the underside of
the Base Unit.
• Press OK to complete the registration process.
NOTE: If after charging the Handset says Searching for Base..., press the NEW
softkey. Enter Base ID will now be displayed. Follow the steps above.
Wait approximately 15 - 60 seconds. You will hear confirmation beeps from the Base
and Handset. The newly registered Handset will now be assigned the lowest exten-
sion number not previously assigned to a different system Handset (1 - 8).
If you do not enter the correct digit sequence, you will see Invalid Base ID! and hear
an error tone. Press the left NavKey to backpace or press the right softkey to
erase a character, and carefully re-enter the Base ID Code.
NOTE: The 15-digit BASE ID Code may contain numbers and characters, including
0 through 9 and*. Make sure you enter all 15 digits.
Congratulations! You can now enjoy the benefits of your VTech Multi-Handset system.
Installation and Registration of Accessory Handset
To Next Page
Loading...
Need help?
General
