120
121
Screen messages
Blocked call An incoming call is
blocked.
Calling HS X
(For models
with two
or more
handsets
only)
The handset is calling
another handset (for
intercom call
Ended You have just ended a
call.
Home
screening...
The telephone is
screening an incoming
home call.
HS X is
calling
(For models
with two
or more
handsets
only)
Another handset is
calling.
Intercom The handset is on an
intercom call.
Intercom to:
(For models
with two or
more devices
only)
You have started the
intercom process,
and need to enter the
number of the device
you wish to call.
Line in use An extension telephone
on the same line or one
of the handsets is in use.
List empty There are no directory
entries or call block list
entries.
Low battery The battery needs to be
charged.
Microphone
on
Mute is off so the other
party can hear your
voice.
Muted The microphone is off.
New
voicemail
There are new voicemail
messages from your
telephone service
provider.
No battery The handset in the
telephone base or
charger does not have
a battery properly
installed.
No line There is no telephone
line connected.
No message There are no messages
in the answering
system.
Not available Someone else is already
using the phonebook,
caller ID log or
answering system.
Number
repeated
The telephone number
you have entered is
already stored in the
phonebook.
Out of range
or no pwr at
base
The handset has lost
communication with the
telephone base.
** Paging ** The telephone base is
paging all handsets.
Smart call blk
screening...
The telephone is
screening an incoming
call.
Speaker The handset
speakerphone is in use.
Voice guide
set Smart call
blk?
After you install your
telephone or power
returns following a
power outage, the
handset and telephone
base will prompt you
to set the date and
time. After the date and
time setting is done or
skipped, the telephone
base will then prompt
if you want to set up
the Smart call blocker
feature via voice guide.
To register
HS... see
manual
The handset is not
registered to any
telephone base.
To screen
call press
[SELECT]
The system is recording
a message. Press
MENU/SELECT to
screen a call on a
handset.
Unable to
call
• Intercom failed.
• You try to join a
call when there are
already four handsets
on that call.
• You try to make a call
when the handset is
out of range.
XX missed
calls
There are XX new calls
in the caller ID log.
XX new
messages
There are XX new
messages in the
answering system.
Put in
charger
The battery is very low.
The handset should be
placed in the telephone
base or charger.
Quiet mode
off
The quiet mode is
turned off.
Quiet mode
on
The quiet mode is
turned on.
Rec mem low The answering system
has less than 3 minutes
to record.
Rec mem full The answering system
memory is full.
Ringer
muted
The ringer is muted
temporarily during an
incoming call.
Screen all
Robocalls
You have selected the
Screen robot profile
option in Smart call
blocker.
Screen all
Unknown
calls
You have selected the
Screen Unknown profile
option in Smart call
blocker.
Screened call The Smart call
blocker feature of the
telephone has screened
a call and is putting the
call through to you.
Setting Ans
sys
The handset is playing
voice guide.
To Next Page
Loading...
Need help?
General
