NOTE: Maintain this pressure for several minutes to increase the
adhesive bond strength.
at room temperature for 1 day before using to allow the ultimate
strength to be achieved. At room temperature, approximately 50% of
the ultimate strength will be achieved after 20 minutes, 90% after 24
hours and 100% after 72 hours.
6. Align the tripod screw hole on the camera to the screw of the adhesive
camera on the mount.
NOTE:
do not tear it off. Otherwise, the adhesive performance may be
reduced and it may not work well for subsequent use. The mount can
be detached from the adhesive part. Push the detachable buckle as
shown in the illustration below to separate the two parts.
Caution:
ACCESSORIES
To Next Page
Loading...
Need help?
General
