CONNECTING TO A COMPUTER
You can connect Kidizoom
®
Duo to a PC or Mac computer using the
included USB cable. Once connected, you can transfer les between
the camera and computer. Please follow the below steps to make the
connection.
• Turn the camera OFF before connecting to a computer.
• Pull up the rubber cover of the USB port at the bottom of your camera.
• Insert the USB cable (small end) into the USB port on the camera.
• Insert the larger end of the USB cable into a USB port on the computer.
A USB port is usually marked with this symbol
.
• Two removable drives called VTech 1708 and VT SYSTEM will
appear. VTech 1708 is for storage of your data, VT SYSTEM is for
storage of system data and cannot be accessed. If there is a memory
card in the camera, the removable drive will show the content on the
memory card only.
To avoid any potential damage to your Kidizoom
®
Duo
• When the USB cable is not connected to the unit, ensure the USB
rubber cover is fully covering the USB port of the camera.
• Please ensure the microSD card slot rubber cover of the camera is
tted in place.
NOTE:
Once the camera is connected to your computer, do not insert or
remove the memory card and do not disconnect the camera while
les are uploading or downloading. After you have nished, remove
the camera by following the steps to safely remove hardware from
your computer. You can then physically unplug the camera from
the computer.
To back up photo or video les taken by the camera:
• Locate and open the DCIM folder in the removable drive VTech 1708.
• Your photos or video les will be placed in the subfolders such as
100VTECH. Drag and drop the les to a location in your computer for
back up.
Connecting To A Computer
To Next Page
Loading...
Need help?
General
