EasyManuals Logo

VTech Kidizoom Smart Watch DX2 User Manual

VTech Kidizoom Smart Watch DX2
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
WEARING THE SMART WATCH
People with very sensitive skin may notice some irritation after wearing
the Kidizoom
®
Smart Watch DX2 for extended periods of time. Skin
may become irritated when moisture, sweat, soap, or other irritants get
trapped under the wristband. To prevent this, we suggest that children
remove the watch before going to bed for the night, to take the watch
off if it's feeling uncomfortable, and keep their wrist and the band clean
and dry.
In addition, wearing the watch too tightly may also cause irritation.
Make sure the fit is good - tight enough so the watch stays in place, but
not so tight that it's uncomfortable. If you notice any redness, swelling,
or other irritation, you may want to consult a doctor before wearing the
watch again.
GETTING STARTED
Master Power Switch
When using the Kidizoom
®
Smart Watch DX2
for the first time, you will need to slide the Master
Power Switch (located on the underside of the
watch) to the ON position . You may need a
small tool such as a paper clip to move the switch
to the ON position. It is recommended to fully
charge the watch before first use. A full charge will
take approximately 3 hours.
When the Master Power Switch is set to the OFF position, the unit
will not function and the battery will not charge. Only move the switch
to the OFF position when the watch will not be used for an extended
period of time.
Note: It is not necessary to switch off the watch in daily use. Once the
Master Power Switch is set to the OFF position, the watch will stop
functioning. After the watch has been turned on again, the time and
date has to be reset.
BATTERY RECHARGING
Note: Adult operation required.
To charge the Kidizoom
®
Smart Watch DX2, the watch needs to be
connected to a computer with the included Micro-USB Cable. To do
so correctly, please follow these steps:
Make sure that the Master Power Switch is set to the ON position
before charging.
Pull up the rubber cover of the Micro-USB Port on the side of the
watch.
6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VTech Kidizoom Smart Watch DX2 and is the answer not in the manual?

VTech Kidizoom Smart Watch DX2 Specifications

General IconGeneral
Memory256 MB internal memory
Age Range4 to 12 years
DisplayColor touchscreen
BatteryRechargeable lithium-ion
ConnectivityMicro USB
FeaturesGames, photo effects, motion sensor
Water ResistanceSplash proof
CompatibilityWorks with VTech Learning Lodge

Related product manuals