• Insert the Micro-USB Cable (small end) into the Micro-USB Port on
the watch.
• Insert the large end of the Micro-USB Cable into a USB port on your
computer. A USB port is usually marked with this symbol:
• Once the connection is successful, you will see a battery recharging
symbol appear on the watch screen.
• Check the charging progress regularly throughout recharging.
• When the battery is fully charged, a message will display on the
screen for a few seconds before the screen automatically turns
off. You may then disconnect your fully charged watch from the
computer.
Note: It will take approximately 3 hours to fully charge the battery. The
actual charging time depends on the charging current, the remaining
charge in the battery prior to recharging, and the ambient temperature.
The optimum ambient temperature is 32°F - 104°F (0°C to 40°C). If
your watch needs a much longer time to fully charge the battery, try a
different USB power source.
BATTERY LIFE
The time the battery lasts between charges depends on play. Like
other electronic devices, more frequent usage will drain the battery
more quickly. Some activities are more demanding on the battery,
such as taking photos and videos. The remaining battery capacity will
appear in the top right corner of the screen. When the battery level
is low, it is recommended to recharge the battery before further use.
When the battery level is too low, the watch will not turn on until it has
been recharged.
Battery Life Approximation
Note: The above battery life approximations are based on the screen
display set to turn off when not in use.
Battery Maintenance
Charge the battery regularly to keep it operating at optimum
performance, even when the watch isn’t regularly in use. For example,
charge the watch at least once every six months. Move the Master
Power Switch to the ON position before recharging the battery. Move
the Master Power Switch to the OFF position if the watch will not be
in use for an extended period of time.
To Next Page
Loading...
Need help?
General
