Telephone operation
27
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to tone dialing
temporarily during a call. This is useful if you need to send touch-tone signals to
access your telephone banking or long distance services.
During a call, press on the handset.
Use the dialing keys to enter the number you wish to dial. The telephone
sends touch-tone signals. The telephone automatically returns to pulse dialing
mode after you end the call.
Find handset/headset
This feature helps you find misplaced handsets and
headset.
To start the paging tone:
Press /FIND HANDSET on the telephone base.
All idle handsets and headset ring and the handsets
display ** Paging ** and the light on the headset
flashes in blue.
To end the paging tone:
To end the paging tone, press /FLASH, /SPEAKER or any dialing key
(0-9, #, ) on the handset, or press on the headset, or press /FIND
HANDSET on the telephone base.
Press OFF/CANCEL or MUTE/DELETE to temporarily turn off the paging tone on
the handset. Its screen shows Ringer muted and .
All registered handsets and headsets ring when being paged even if the ringer
volume is set to off.
•
•
1.
2.
•
•
To Next Page
Loading...
Need help?
General
