15
Charge the Parent Unit Battery
The parent unit operates on an internal rechargeable battery or AC power. To
continuously monitor your baby, keep the parent unit connected to AC power.
When the parent unit is used on the internal batteries, the operating time will vary
according to the initial state of charge and the settings.
Notes:
• Before using the baby monitor for the rst time, charge the parent unit battery for 12 hours.
The red battery LED light flashes during charging. When the parent unit battery is fully
charged, the battery LED light and the battery icon segments are solid .
• The standby time varies depending on your actual use.
The battery icon indicates the battery status (see the following table).
Battery Indicators Battery Status Action
The screen displays
and .
The light ashes.
The battery has very little
charge and may be used
for only a short time.
Charge without interruption
(about 30 minutes).
The battery icon
segments are solid
.
The battery is fully
charged.
To keep the battery
charged, connect it to AC
power when in use.
To Next Page
Loading...
