Turn on/off the parent unit screen
You can turn on or off the parent unit screen without powering off the parent unit. You can still hear sound from the baby unit.
Press POWER on the parent unit to turn off the screen.
Press any keys on the parent unit to turn on the screen again.
Tip
You can reset the parent unit by pressing the RESET key at the back of the unit.
Use a pin and insert it into the hole on the back of the parent unit, and then press the button inside.
Test the sound level and position the HD video monitor
NOTE
This HD video monitor is intended as an aid. It is not a substitute for proper adult supervision, and should not be used as such.
Testing the sound level of the HD video monitor
CAUTION
For hearing protection, make sure the parent unit is more than 3 metres away from the baby unit. If you hear any high-pitched noise from the parent unit, move the parent
unit further until the noise stops. You can also press – VOL on the parent unit to lower or mute the noise.
TIP
Increase the parent unit speaker volume if you cannot hear the sounds transmitted from the baby unit.
Positioning the HD video monitor
Keep the baby unit out of the reach of your baby. Never place or mount the baby unit inside the baby’s crib or playpen.
To Next Page
Loading...
Need help?
General
