13
Additional Information
Wall Mount (Optional)
Notes:
• Check for reception strength and the camera viewing angle before drilling the holes.
• The types of screws and wall plugs you need depend on the composition of the wall. You
may need to purchase the screws and wall plugs separately to mount your camera.
1� Place the wall mount bracket on a wall and then use a pencil to mark the top
and the bottom holes as shown. Remove the wall mount bracket and drill two
holes in the wall (5.5mm drill bit).
2� If you drill the holes into a stud, go to step 3.
If you drill the holes into an object other than a stud, insert the wall plugs into
the holes. Tap gently on the ends with a hammer until the wall plugs are ush
with the wall.
To Next Page
Loading...
