10
Getting started
Parent unit battery installation
You can power up the parent unit by connecting it to AC power or to the
rechargeable battery provided. Even if the parent unit is connected to
AC power, we recommend you also install the battery. This guarantees
continual operation in case of a power outage.
Install the battery as shown below.
With the label THIS SIDE UP facing up, insert the small tabs of the battery
into the slots inside the battery compartment. Make sure the metallic contact
is correctly oriented as shown below. Push the battery into the battery
compartment until it clicks securely into place.
Align the battery compartment cover flat against the battery compartment,
then slide it towards the center of the parent unit until it clicks into place.
1.
2.
Metallic
contact
To Next Page
Loading...
Need help?
General
