12
Getting started
Parent unit installation
Install the parent unit as shown below.
Make sure that the power outlet is not controlled by a wall switch. Bundle the
adapter cord neatly with the attached self-adhesive strap.
Parent unit
Use only the parent unit power adapter supplied with this product.
To order a replacement, visit our website at www.vtechcanada.com or call
1 (800) 267-7377.
The parent unit power adapter is intended to be correctly oriented in a vertical or
floor mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Make sure the parent unit and the power adapter cord are out of reach
of children.
•
•
•
Power outlet not
controlled by a
wall switch
Parent unit
power adapter
Self-adhesive
strap
If the battery
is installed,
the light on
the parent unit
turns on while
charging.
Raise the antenna
for better reception.
To Next Page
Loading...
Need help?
General
