VTech Safe & Sound User Manual

37
Appendix
Troubleshooting (continued)
The link between the baby unit and the parent unit is lost every now and
then, and I’m experiencing sound interruptions.
Move the parent unit closer to the baby unit (but not less than 3 feet). The baby units
may be out of range.
Reset the parent unit and the baby unit by turning them off and unplugging the electrical
power to the parent unit and the baby unit. Wait for 15 seconds and plug them back in
again. Turn on the baby unit and the parent unit. Allow up to one minute for the parent
unit and the baby unit to synchronize.
Other electronic products may cause interference with your video and audio monitor.
Try installing your video and audio monitor as far away from these electronic devices
as possible: wireless routers, radios, cellular telephones, intercoms, room monitors,
televisions, personal computers, kitchen appliances and cordless telephones.
The parent unit displays Waiting for linking...
Move the parent unit closer to the baby unit (but not less than 3 feet). The baby units
may be out of range.
Reset the parent unit and the baby unit by turning them off and unplugging the
electrical power to the parent unit and the baby unit. Wait for 15 seconds and plug
them back in again. Turn on the baby unit and the parent unit. Allow up to one
minute for the parent unit and the baby unit to synchronize.
Other electronic products may cause interference with your video and audio
monitor. Try installing your video and audio monitor as far away from these
electronic devices as possible: wireless routers, radios, cellular telephones,
intercoms, room monitors, televisions, personal computers, kitchen appliances and
cordless telephones.
Common cure for electronic equipment.
If the video and audio monitor is not responding normally, try the following (in the
order listed):
1. Disconnect the power to the baby units and the parent unit.
2. Remove the batteries in the baby units and the parent unit. Then install the
batteries again.
3. Wait a few minutes before connecting power back to the baby units and the
parent unit.
4. Turn on the baby units and the parent unit.
5. Wait for the parent unit to synchronize with the baby units. Allow up to one minute for
this to take place.
•
•
•
•
•
•
•

VTech Safe & Sound Specifications

General

Brand	VTech
Model	Safe & Sound
Category	Baby Monitor
Language	English