8
Getting started
Planning your system
Use the existing Ethernet wall jack:
Use the PC port on the console as an Internet pass-through.
Unplug your Ethernet cable of your computer from the existing Ethernet
wall jack.
Plug one end of the Ethernet cable into the Ethernet port (
) at the back of
the console and the other end into the Ethernet wall jack.
Connect your computer to the Ethernet network through the PC port (
) of
this console.
NOTES:
The PC port does not function when there is no power connected to this console. Refer to pages
11 - 16 for installation instructions.
This telephone system does not support Power over Ethernet (PoE).
If you are using the Gigabit Ethernet system, the connection speed of your computer will
be slower.
Set up a new network:
Contact your technical support for the Ethernet network setup.
Make sure your Ethernet switch or router has enough slots to accomodate
the console, each deskset and your computers. Refer to pages 11 - 16 for
installation instructions.
1.
2.
3.
•
•
•
Use only
Supplied
Adapter
L4 L3/4 L2 L1/2
5.1
To Next Page
Loading...
Need help?
General
