11
Plug the end of the coiled handset cord into the
jack on the left side of the telephone.
1.
Lift the kickstand as the arrows indicate below to release it from the groove.
There are seven pairs of grooves designed to hold the console at different
angles for optimum visibility.
2.
Do not power up the console until you have plugged in all telephone
lines and the Ethernet cable as instructed in steps 4-5.
The power adapter is intended to be correctly oriented in a vertical or
floor mount position. The prongs are not designed to hold the plug in
place if it is plugged into a ceiling, under-the-table or cabinet outlet.
•
•
Getting started
Console installation
To Next Page
Loading...
