VTI Instruments Corp.
60 EX1200 Series Preparation for Use
FIGURE 2-19: COMPLETED EX1200 MAINFRAME STATIC IP CONFIGURATION
8) Click the Submit button. Once this is done, it is no longer possible to communication with the
EX1200 mainframe. This is normal and is addressed in the following steps.
9) Set a static IP address for the NIC card by doing the following:
a) Navigate to Start → Settings → Network Connections.
b) Right click on the NIC card that the EX1200 mainframe is connected to and select
Properties.
c) Select Internet Protocol (TCP/IP) and click Properties.
FIGURE 2-20: TCI/IP SELECTION
d) Click the Use the following IP address radio button.
To Next Page
Loading...