www.vtiinstruments.com
EX1200 Series Preface 7
GENERAL SAFETY INSTRUCTIONS
Review the following safety precautions to avoid bodily injury and/or damage to the product.
These precautions must be observed during all phases of operation or service of this product.
Failure to comply with these precautions, or with specific warnings elsewhere in this manual,
violates safety standards of design, manufacture, and intended use of the product. Note that this
product contains no user serviceable parts or spare parts.
Service should only be performed by qualified personnel. Disconnect all power before servicing.
TERMS AND SYMBOLS
These terms may appear in this manual:
Indicates that a procedure or condition may cause bodily injury or death.
Indicates that a procedure or condition could possibly cause damage to
equipment or loss of data.
These symbols may appear on the product or in the manual:
ATTENTION - Important safety instructions
Indicates hazardous voltage.
Indicates that the product was manufactured after August 13, 2005. This mark is
placed in accordance with EN 50419, Marking of electrical and electronic
equipment in accordance with Article 11(2) of Directive 2002/96/EC (WEEE).
End-of-life product can be returned to VTI by obtaining an RMA number. Fees
for take-back and recycling will apply if not prohibited by national law.
Follow these precautions to avoid injury or damage to the product:
The power cable provided with this instruments meets the required
regulatory and statutory safety standards as indicated by this
product’s declaration of conformity. VTI recommends that the
power cord provided be used with the instrument that it is provided
with. If a different power cord is must to be used, however, it is the
responsibility of the user to select a power cord that meets any and
all regulatory and statutory requirements for their industry and
country.
To avoid electrical overload, electric shock, or fire hazard, do not
use a power source that applies other than the specified voltage.
The mains outlet that is used to power the equipment must be
within 3 meters of the device and shall be easily accessible.
To avoid fire hazard, only use the type and rating fuse specified for
this product.
Prior to using EX1200 series plug-in modules, it is imperative that
the power consumption of all modules that will be installed in the
To Next Page
Loading...