VTI Instruments Corp.
8 EX1200 Series Preface
mainframe be calculated for all power supply rails. The required
information can be found in Appendix B of the EX1200 Series
User’s Manual (P/N: 82-0127-000). Failure to do so may result in
damaging the switch card and the mainframe.
To avoid electric shock or fire hazard, do not operate this product
with the covers removed. Do not connect or disconnect any cable,
probes, test leads, etc. while they are connected to a voltage source.
Remove all power and unplug unit before performing any service.
Service should only be performed by qualified personnel.
This product is grounded through the grounding conductor of the
power cord. To avoid electric shock, the grounding conductor must
be connected to earth ground.
To avoid injury, electric shock or fire hazard:
Do not operate in wet or damp conditions.
Do not operate in an explosive atmosphere.
Operate or store only in specified temperature range.
Provide proper clearance for product ventilation to prevent
overheating.
When selecting the installation location, be certain that there is
enough space around the power plug and the outlet so that they
are readily accessible. Do not insert the power cord into an
outlet where accessibility to the plug cord is poor.
All unused slots should be closed with the dummy filler panels
to ensure a proper air circulation. This is critical to avoid
overheating of the cards.
DO NOT operate if any damage to this product is suspected.
Product should be inspected or serviced only by qualified
personnel.
The operator of this instrument is advised that if the equipment is
used in a manner not specified in this manual, the protection
provided by the equipment may be impaired.
Conformity is checked by inspection.
To Next Page
Loading...