www.vtiinstruments.com
EX1200 Series Preparation for Use 61
e) Enter the desired IP address. If using the IP from the example above, 192.168.1.1 can be
used.
f) If not automatically completed after the IP address is entered, set the Subnet mask field
to 255.255.255.0.
FIGURE 2-21: COMPLETED NIC STATIC IP CONFIGURATION
g) Click OK to exit the network configuration properties.
TIME CONFIGURATION
The EX1200 will initially be configured to receive its time through PTP (Precision Time
Protocol). The user can also set time using SNTP (Simple Network Time Protocol) or the time
can be set manually. The manual setting is necessary if the network environment is such that the
unit cannot reach the Internet. For more information, see Time Configuration in Section 7.
To Next Page
Loading...