6.2. Support type
Add key support type
W164
W164 2009-
W166, 197, 212, 218, 246
W169, 209, 211
W172, 204, 207, 212(old with ELV)
W216
W221
W639 2009-
Lost all key support type
W166, 197, 212, 218, 246
W212 (old with ELV)
6.3. Functions
Mode: OBD and IR adaptor, mode use for communicate with EIS
Chassis: Select chassis number, you can detect it with auto detect in EIS Tools
Data Acquisition:
Press “Data Acquisition”, it will continue with following steps automatically
1. Insert working key to ignition, waiting 15 seconds
2. Insert working key to device IR reader, verify key and car
3. Data acquisition
4. Insert working key to ignition, waiting 30 seconds
5. Insert working key to device IR reader, wait end...
6. Save acquisition data
Upload Data: Upload saved acquisition data to server for calculate password. Attention:
Once success calculate password for one SSID, the server will not accept calculate the
acquisition data with same SSID in 2 hours. After 2 hours, acquisition data with same
SSID upload to server will start with a new task
Query result: Query server calculation result. The password will fill in key password area
automatically after success calculation. Use “Copy” copy password to clipboard
Auto reflash: Program will auto re-flash server result until there’s no task for this device.
You can start data acquisition once more while auto reflash starting
Stop acquisite after success: If you are run data acquisition while auto reflash running,
program will stop the acquisition progress when find correct password
To Next Page
Loading...