VWR Collection PCR Workstation
7
ASSEMBLING THE PCR WORKSTATION
The PCR Workstation should be assembled by two people, directly at the site of operation. We
recommend the wearing of safety gloves for hand protection.
Step 1
Put the base 1 on an even surface with the
rubber feet facing down and the sensor
cable outlet facing to the front. Lay the back
panel 2 onto the base 1 with the power
outlets facing down, and the power input
and the type label facing to the right.
Connect both sensor cables.
Slide the connection assembly into the
cavity of the back panel.
Base 1
Back panel 2
To Next Page