VXI B250-XT - Page 9

9
ON / STANDBY / OFF
VXi BlueParrott
®
B250-XT+ User Guide
Turn Headset On: Hold down the MFB for approximately 2–3 seconds until you hear a voice
prompt, “Power on.” The red light will flash once every second.
Standby Mode: Once the headset is turned on (after the initial pairing), it will attempt to connect
to the last device that it was paired with, putting itself into standby mode. (The headset can also
beputintostandbymodewithaquickpressandreleaseoftheMFB).Thebluelightwillflashindi-
cating an active Bluetooth link. The headset will have a voice prompt, “Your headset is connected.”
Turn Headset Off (conserves battery power): Hold down the MFB for approximately 4–5 seconds
until you hear a voice prompt, “Power off.” A red light will flash 4 times and the headset will turn off.