W'eau MiniPool YC-005TB1 - Page 6

- 4 -
tocirculatethroughtheheatpump.Theheatpumpwillnotstartupifthewaterisnotcirculating.

3.3Electricalconnection
Beforeconnectingtheunit,verifythatthesupplyvoltagematchestheoperatingvoltageoftheheatpump.
TheRCDplughasbeenincludedwithpowercable,whichcan
offer electricalprotection.
Attention:
Ensurethepowerplugissecure
Iftheplugisnotsecure,itmaycause
anelectricshock,over‐heatingor
fire

Neverpulloutthepowerplugduring
operation
Otherwise,itmaycauseanelectric
shockorafireduetoover‐heating.


Neverusedamagedelectricwires
orunspecifiedelectricwires.
Otherwiseitmaycauseanelectric
shockorafire.



Afterallconnectionshavebeenmadeandchecked,carryoutthefollowingprocedure:
1. Switchonthefilterpump.Check forleaksandverifythatwaterisflowingfromandtotheswimmingpool.
2. Connect power to the heat pump and press the On/Off buttonon the electronic control
panel. The
unitwillstartupafterthetimedelayexpires(seebelow).
3. Afterafewminutes,checkwhethertheairblowingoutoftheunitiscooler.
4. Whenturnoffthefilterpump,theunitshouldalsoturnoffautomatically.
Dependingontheinitialtemperatureofthewater
intheswimmingpoolandtheairtemperature,itmaytake
some time to heat the water to the desired temperature. A good swimming pool cover can dramatically
reducetherequiredlengthoftime.
Timedelay‐ Theheatpumphasabuilt‐in3‐minutestart‐updelaytoprotect
thecircuitryandavoidexcessive
contactwear.Theunitwillrestartautomaticallyafterthistimedelayexpires.
If first power on or additional power interruptions, the heat pump starts 10s later after pressing ‘ON/OFF’
button.
3.4Condensation
Theairdrawnintotheheatpumpisstronglycooledbytheoperationof
theheatpumpforheatingthepool