W'eau MiniPool YC-005TB1 - Display Controller Operation

- 6 -

5. Displaycontrolleroperation
5.1Theinterfaceofcontroller

 Whentheheatpumpisrunningorstandby,thedisplayshowsthewaterinlettemperature.
WhentheheatpumpisPower‐on,thedisplayshows‘OFF’
willlightonwhenyouturnonthemachine.
Whendefrosting,willbelightingon,willflash.
Turnon/off
theheatpump
Pressto turn on the heat pump, the LED display shows the water setting temperature for 3s, then
showwaterinlettemperature.
pressagaintoturnofftheheatpump,itwillshow‘OFF’onthedisplay.
NOTE:Thereis3minioftimedelayprotectionfor
thecompressor.

5.3Setthedesiredwatertemperature
Pressordirectly to adjust the desired water temperature, the data will be saved in 3
seconds.
NOTE:Theheatpumpcanbeoperatingonlyifthewatercircle/filtrationsystemisrunning.

5.4SwitchCelsius(℃)andFahrenheit(℉)