: It will flash when there is Error code or system protection or water flow protection.
6.8 Manual defrosting
Hold and for 5 seconds, and when the Piping temp. is below than Exit defrosting temp.,
the system can enter into Manual defrosting.
6.9 Factory setting recovery
When machine has been connected power cable and under standby situation, hold + +
+ for 3 seconds to recover factory setting.
6.10 Parameters Setting
On the main interface, hold for 3 seconds to enter Parameter setting. Press and
to check the parameter from P01~P05, press to select the parameter, then press
and to adjust the data, then press again to save the data. Press to go back the
main interface.
To Next Page
Loading...
