EasyManua.ls Logo

Wacker Neuson BPU 2540

Wacker Neuson BPU 2540
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
T01092en.fm 19
7. Operation
7.1 Start preparation
Before you start the engine, check the following:
f Fuel level – the tank should be at least half full.
f Motor oil level.
f Air filter.
f Fuel lines for leaks.
f External screw connections for tightness.
7.2 Starting the engine
f Open the fuel tap (a1).
f Cold start: Close the choke (d2).
Warm start: Open the choke (d1).
Note: The engine is hand warm or hotter with warm start.
f Set the engine switch to "ON" (b2).
f Push the throttle lever to the left (c2).
f Pull out the starter rope (e) until compression resistance can be felt and then
let it roll back in again.
f Pull the starter rope with force, but not suddenly.
The engine starts.
f Let starter rope slowly roll back in.
f Open the choke while the engine is warming up.
f Open the throttle lever completely for operation (c1).
a1
a2
b2
b1
c1
c2
c3
d2
wc_gr000655
e
d1

Related product manuals