Safety information
SV00069en.fm 9
2.2.13 Wear suitable protective clothing during work and maintenance work.
2.2.14 When operating in the reverse direction, the operator must operate the
vibrating plate from the side in order to protect themselves from being
crushed between the end of the guide handle / machine and an
obstacle. Great care is necessary when working on uneven terrain and
compacting large materials. A safe distance must be kept here.
2.2.15 Vibrating plates are to be guided in such a way that hand injuries
caused by solid objects are avoided.
2.2.16 Vibrating plates must be so installed and operated that their vertical
stability is ensured.
2.2.17 Machines with integrated driving mechanisms must not be set down or
stored on the chassis. The driving mechanism is only intended for the
transport of this machine.
2.3 Safety checks
2.3.1 Vibrating plates may only be operated with all safety devices installed.
2.3.2 Before starting operation, the operator has to check that all control and
safety devices are functioning properly.
2.3.3 If defects on the safety devices or other defects impairing the
operational safety of machine are observed, the supervisor must be
informed immediately.
2.3.4 If there are defects jeopardizing operational safety, the machine has to
be switched off immediately.
2.3.5 All auxiliary materials, fuel, lubricants and coolants are to be stored in
marked containers according to the manufacturer's regulations.
To Next Page
Loading...
Need help?
General
