Safety information
SV00069en.fm 8
2.2.3 The operator must not leave the operator's area during the operation
of the machine.
2.2.4 Before going on breaks, the operator must switch off the motor of the
machine. The machine must be set down so it cannot tip over.
2.2.5 The tank may only be filled when the motor is switched off and the fuel
must not make contact with hot parts or fall on the ground.
2.2.6 Open flames and smoking are strictly prohibited in the immediate
vicinity of this machine.
2.2.7 The tank lid must be tightly secured. When the motor is switched off,
the fuel tap - if there is one - must be closed. When transported over
long distances, the tank of gasoline or mixed gasoline driven engines
must be completely emptied.
Leaking fuel tanks can lead to explosions and therefore must be
replaced immediately.
2.2.8 Do not operate this machine in areas where explosions may occur.
2.2.9 While operating vibrating plates with a combustion motor in closed
rooms, tunnels, drifts or deep trenches make sure that there is a
sufficient intake of fresh air.
2.2.10 While operating vibrating plates, keep hands, feet and clothing away
from moving parts. Protective shoes must be worn.
2.2.11 While working on cracked, cavity, acclivity or escarpment edges and
on trench edges and steps, operate the vibrating plates so that they
cannot tip over or fall down.
2.2.12 A sufficient load-bearing capacity of the surface or foundation to be
compacted must be ensured.
To Next Page
Loading...
Need help?
General
