Maintenance
T00963GB 52
8.6 Checking the ignition spark
Insert the combination wrench (9) between the hood and cylinder only
as shown.
ATTENCION!
Do
not insert the combination tool into the spark plug hole, but make
contact only with the cylinder (otherwise you may damage the engine).
Using
insulated pliers, hold the spark plug (10) (unscrewed but with the
plug cap on) against the combination tool (away from the spark plug
hole!).
Switch the combination switch (11) to “I“.
Pull the starter rope hard.
If the function is correct, an ignition spark must be visible near the
electrodes.
58
To Next Page
Loading...
