8 Operation and use
100_0202_op_0011.fm 39
8.5.4 Charge rechargeable battery (remote control)
Charging rechargeable battery with charging cable
Connecting the charging cable
1. Open rear protective hood.
2. Unscrew screwed nose cap from the connection socket of the remote control.
3. Remove the charging cable from the bracket.
4. Plug charger cable into the connector on the remote control and screw in.
5. Place remote control in the bracket.
6. Close rear protective hood.
NOTICE
Charging the battery at temperatures below 0°C may not be possible.
NOTICE
After connecting the charging cable to the remote control, the rechargeable battery is
loaded. Overcharging the battery is not possible; the charging cable must not be
disconnected from the remote control after charging. Note that after a longer downtime/
service life of the machine, the rechargeable battery charges more slowly. It may need to
be recharged.
A charging time of 15 min is sufficient to operate the machine for about 1 h.
Item Designation Item Designation
1 Remote control 4 Bracket for charger cable
2 Bracket for remote control 5 Socket with screwed nose cap
3 Charge cable
NOTICE
Improper handling can result in damage to the charging cable.
When using charging cable, make sure it will not get pinched when closing the
protective hood.
NOTICE
The loading of the remote control lamp lights up green when the rechargeable battery
is charging.
The loading of the remote control lamp goes out once the rechargeable battery is
charged.
To Next Page
Loading...
Need help?
General
