5-38 BA DT10 en<> - Edition 1.5 * * dt10b550.fm<>
Maintenance
Check alternator, starter and electric connections, bearing play and function
●●
Pressure check of primary pressure limiting valves
●● ●
Check tracks for cracks and cuts
●●
Check the track tension and retension the tracks if necessary
●●
Bearing play of tread rollers, track carrier rollers, front idlers
●●
Check piston rods for damage
●●
Check screws for tightness
●●
Pin lock
●●
Line fixtures
●●
Adhesive labels and Operator’s Manual
●●
Lubrication service ( ):
Lubricate the following subassemblies/elements: – see Lubrication schedule DT10 with front tip skip, front tip skip for
lightweight material (optional) on page 5-39:
• Tipping trailer ●●
• Tilt cylinder ●●
• Self-loading equipment (option) ●●
• Self-loading equipment cylinder (option) ●●
• Rotary cylinder (option) ●●
• Turntable (option) ●●
• Track tension ●●
• Track roller bearings ●●
Leakage check ( ):
Check for tightness, leaks and chafing: pipes, flexible lines and screw connections of the following assemblies and components. Repair if necessary:
• Visual check
●●
☞Engine and hydraulic system ●●
☞Oil cooling circuit ●●
☞Travel drive ●●
1. Replace the engine oil for the first time after 50 o/h or the first month, then every 250 o/h or after 6 months at the latest
2. Replace the engine oil filter for the first time after 50 o/h or the first month, then every 250 o/h or after 6 months at the latest
3. Replace the fuel filter for the first time after 50 o/h or the first month, then every 250 o/h or after 6 months at the latest
4. Replace the hydraulic oil filter for the first time after 50 hours run or the first month, then every 250 hours run or after 6 months at the latest
5. Check and adjust injection time every other 1000 o/h servicing
6. Clean and adjust the fuel injection pump every other 1000 o/h servicing
5.10 Maintenance plan DT10
Work description
For servicing and maintenance on the attachment, please refer to the operation and maintenance manual of the attach-
ment manufacturer as well.
Maintenance plan/operating hours (o/h)
Service work
(daily)
Once a month or
after 50 o/h
Every 6 months or
after 250 o/h
Every 12 months or
after 500 o/h
Every 3 years and/or
after 1000 o/h
Customer
Service center
service center
To Next Page
Loading...
Need help?
General
