Wacker Neuson DT10

BA DT10 en - Edition 1.5 * * dt10b550.fm 5-37
Maintenance
5.10 Maintenance plan DT10 Work description For servicing and maintenance on the attachment, please refer to the operation and maintenance manual of the attach- ment manufacturer as well.
Maintenance plan/operating hours (o/h)
Service work
(daily)
Once a month or
after 50 o/h
Every 6 months or
after 250 o/h
Every 12 months or
after 500 o/h
Every 3 years and/or
after 1000 o/h
Customer
Service center
service center
Fluid and filter changes ( ): Perform the following oil and filter changes (check oil levels after test run):
• Engine oil
1
●●
●
• Engine oil filter
2
●● ●
• Replace the fuel filter element
3
●
●●
• Replace the air filter element ●● • Hydraulic oil filter insert
4
●● ●
• Cartridge of hydraulic oil intake filter ●● • Hydraulic oil ●● • Coolant ●● • Replacing fan belts ●●
Inspection work ( ): Check the following material. Refill if necessary: Check injection setting
●●
Check and adjust injection time
5
●
●
Clean and adjust the fuel injection pump
6
●
●
Check and adjust the injection pressure of the injection nozzles, clean the injection needles/nozzles
●
●
Check/set the maximum engine speed ●● Clean the filter cup ●● Check condition and injection of fuel injection nozzle ●● Check the fuel level, add fuel ●●
• Engine oil ●● • Hydraulic oil ●●
Check hydraulic oil radiator for dirt, clean if necessary
●●
Check oil cooling systems and hoses for leaks and pressure (visual check)
●●
Air filter (damage)
●●
Check the exhaust system for damage and condition
●●
Intake and exhaust valve clearance
●●
Check battery electrolyte. Add distilled water if necessary
●● ●
Maintenance