EasyManuals Logo

Wacker Neuson DT10 User Manual

Wacker Neuson DT10
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
BA DT10 en - Edition 1.5 * dt10b510.fm 5-1
Maintenance
5 Maintenance
5.1 Introduction
The working order and the service life of vehicles are heavily dependent on maintenance.
It is therefore in the interest of the machine owner to perform the mandatory maintenance.
Before performing servicing and maintenance, always read, understand, and follow the
instructions given in:
Chapter 2 “Safety instructions” of this Operator’s Manual and
The Operator’s Manuals of the attachments.
Daily maintenance specified in maintenance plan “A” has to be performed by an appropri-
ately trained machine operator. All other maintenance may only be performed by trained
and qualified technical personnel.
The maintenance plans indicate when the maintenance mentioned below must be per-
formed.
Maintenance prop
Danger!
Careful when performing maintenance on or under the skip, and in general
when performing maintenance with the skip tilted out –
Accident hazard!
Use the maintenance prop
Proceed as follows to attach the maintenance prop:
Remove the maintenance prop A from the transport bracket
The maintenance prop is fastened with lock pin C and pin D
Insert the maintenance prop A on the tipping cylinder B
Secure the maintenance prop A with the locating pin C and the pin D
During transport fit maintenance point A in the seat as shown in Fig. 59.
A
B
D
C
A
Fig. 59: Maintenance prop
Fig. 59: Transport bracket

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson DT10 and is the answer not in the manual?

Wacker Neuson DT10 Specifications

General IconGeneral
BrandWacker Neuson
ModelDT10
CategoryConstruction Equipment
LanguageEnglish

Related product manuals