BA DT10 en - Edition 1.5 * dt10b330.fm 3-21
Operation
Crane handling the machine
Safety instructions
• The crane and the lifting gear must have suitable dimensions
• Crane-lifting the machine requires suitable lifting gear
• Secure the machine against unintentional movement!
Incorrect crane-lifting of the machine –
Accident hazard!
☞Ensure that no one is near the machine!
☞Have loads fastened and crane operators guided by experienced persons
only! The person guiding the crane operator must be within sight or sound
of him.
☞Ensure that the crane and the lifting gear (cables, chains) have sufficient
lifting capacity!
☞Only raise the machine with an empty loader unit and skip
☞Stay clear of suspended loads!
☞It is essential that you read the safety instructions at the beginning of this
chapter and follow any other safety instructions relevant in your country!
☞Load the machine as follows:
• Empty the skip and the loader unit
• Lower tipping trailer
• Stop the engine
• Remove the starting key.
• Use suitable lifting gear, chains, etc.
☞Length L1 of the lifting gear on the skip must be at least 2.0 m long
☞Length L2 of the lifting gear (two cables or chains) on the control stand must be at
least 2.0 m long
• Slowly raise the machine
Fig. 46: Crane-lifting
L1
L2
L2
L1
L2
L1
L2
L1
L2
L1
L2
To Next Page
Loading...
Need help?
General
