3 Security
100_0101_si_0007.fm 12
Protect the flexible shaft (component of the HMS)
Do not excessively bend or kink the flexible shaft.
Do not pull the flexible shaft over sharp edges.
If the flexible shaft has become jammed in the reinforcement, switch off the drive motor and disconnect
the flexible shaft from the drive motor. Then release the clamped flexible shaft by carefully moving it back
and forth.
Switch off the unit
Switch the equipment off and remove the plug from the plug receptacle in the following situations:
Before breaks.
When you are not using the equipment.
Before putting the equipment down, wait until it comes to a complete standstill.
Set the equipment down so that it cannot tip over, fall down or slip.
Storage
Set the equipment down so that it cannot tip over, fall down or slip.
Storage location
After operation, store the cooled equipment in a locked, clean, frost-protected and dry location that is
inaccessible to children.
Vibration load of the HMS
Vibration-induced long-term damage cannot be ruled out entirely during intensive use of walk-behind
drive motors.
Observe the respective statutory provisions and guidelines in order to keep the vibrations to a minimum.
You can find information about the vibration load of the HMS in the chapter Technical Data.
3.6 Safety when operating hand-held equipment
Working safely with hand-held equipment
While working, only hold the equipment by the handle intended solely for this purpose.
Always keep the power cable behind and away from the drive motor and keep the power cable away
from the working area of the vibrator head.
Ensure that the air intakes and outlets are clear.
Setting down hand-held equipment properly
Carefully lay down the equipment. Do not throw the equipment on the floor or from great heights. When
thrown down, the equipment can injure other people or even be damaged itself.
3.7 Safety when operating electrical equipment
Specific regulations for electrical equipment
Observe the safety instructions in the General safety instructions brochure from the equipment's
standard package.
Also observe the country-specific regulations, standards and directives for accident prevention in
conjunction with electrical systems and equipment.
WARNING Read all safety instructions and information Failure to comply with the safety
information and instructions can cause electric shock, fire and / or serious injuries.
Save all safety information and instructions for the future.
To Next Page
Loading...
Need help?
General
