10 Operation
100_0101_op_0011.fm 25
10 Operation
10.1 Before commissioning
Previous conditions for operation
The HMS may only be operated under the following previous conditions:
The HMS is pre-assembled according to this operator's manual:
The vibrator head is bolted onto the flexible shaft.
The flexible shaft (including vibrator head) is coupled with the drive motor.
Check equipment
Check the HMS and all components for damage.
Check for a firm seat of the flexible shaft in the drive motor.
Check the shoulder strap for damage.
Check the power supply system
Check whether the power supply system or construction site electrical distributor has the correct
operating voltage (see nameplate of the equipment or chapter Technical Data).
Check whether the power supply system or construction site electrical distributor are verified
according to the applicable national standards and guidelines.
10.2 Commission
Connect the HMS to the electric power supply
WARNING
Improper handling can lead to injuries or serious damage to property.
Read and observe all safety instructions in this operator's manual, see chapter Safety.
WARNING
Leak current due to moisture penetration.
Injury from electric shock.
In a humid environment, hold or stop the equipment in the operative position.
Use the extension cable in IPx4 design so that the connection link of the plug /
coupling is splash-water protected.
NOTICE
For longer flexible shafts, Wacker Neuson recommends using a shoulder strap.
NOTICE
Electrical voltage.
An incorrect voltage can damage the equipment.
Check whether the voltage of the power source conforms to the specifications of the
equipment, see chapter Technical Data.
WARNING
Electrical voltage.
Injury from electric shock.
Check power cable and extension cable for damage.
Only use extension cables whose grounded conductor is connected to the plug and
coupling (only for equipment of class rating I, see chapter Technical data).
To Next Page
Loading...
Need help?
General
