Why does the spray jet pulsate on my WAGNER FLEXIO 3500 Paint Sprayer?
If the spray jet on your WAGNER Paint Sprayer pulsates, it could be because the material in the container is running out, so refill it. Another possible cause is a clogged air filter, which would need to be changed.
What to do if the spray jet pulsates on my WAGNER FLEXIO 3500?
If the spray jet on your WAGNER Paint Sprayer is pulsating, it could be due to the material in the container running out; refill it. Another cause might be a clogged air filter, which you should change. Also, check the vent hole on the suction tube for clogs and clean it if necessary.
Electrical product grounding procedures to prevent shock hazards.
Guidelines for safe use of extension cords and electrical connections.
Recommended settings for coatings, material flow, and air power.
Step-by-step guide for flushing the sprayer after use.
Causes and solutions for little or no material flow from the sprayer.
Causes and solutions for material leaks from the sprayer.
Causes and solutions for spray patterns that are too thick, run, or sag.
Causes and solutions for a pulsating spray jet output.
General| Power Source | Electric |
|---|---|
| Flow Rate | Up to 8.0 gallons per hour |
| Nozzle Included | Yes |
| Spray Patterns | Horizontal, Vertical |
| Nozzle Type | iSpray Nozzle |
| Usage | Indoor/Outdoor |
| Spray System | Airless |
| Container Capacity | 1.5 qt |
| Warranty | 1 year limited |
| Flow Control | Adjustable |
| Weight | 6.6 lbs |
To Next Page